Engine oil additive for crankcase / for vehicle engines, diesel/lpg/petrol K2 T371

K2 MOTOR FLUSH 250 ML

K2 Motor Flush is a professional engine flush with a proven formula based on cleaning agents, lubricants, and anti-wear additives. It removes carbon deposits, oil sludge, and soot.

It dissolves contaminants blocking piston rings, increasing their tightness. Tight rings mean increased compression and reduced oil consumption. K2 Motor Flush dissolves even the oldest carbon deposits, sediments, and other dirt in the engine lubrication system within a few minutes. It restores full flow capacity to oil channels.

Thanks to its refined formula and high effectiveness, the K2 Motor Flush engine flush:

• removes deposits, carbon deposits, oil sludge, and soot from inside the engine
• restores full flow capacity to oil channels
• reduces smoking and emission of environmentally harmful exhaust gases
• increases power by freeing stuck piston rings
• raises compression in cylinders
• reduces oil consumption
• quiets the engine, eliminates noise from valve lifters

The K2 Motor Flush engine flush can be used in all combustion engines – diesel, petrol, and gas-powered. Special lubricating additives in the flush protect the engine from excessive friction that may occur due to oil dilution after adding the flushing agent. K2 Motor Flush is completely safe for the engine.

It is recommended to use the K2 Motor Flush engine flush especially in cases of:

• using oil older than 12 months
• purchasing a car with an engine whose history is unknown
• using the car mainly in urban mode (city driving, short distances)
• engine burning oil (excessive oil consumption)
• excessive "smoking" (black or blue smoke from the exhaust)
• low compression
• oil leaking through the breather
• exceeding the recommended oil change interval (driving on used oil)

It is recommended to use the engine flush at least once a year, preferably with every engine oil change. This will help keep the power unit clean, increase its efficiency, and extend its lifespan. Black deposits can be permanently eliminated with regular use of the product.

One package is sufficient for 4-6 litres of oil. In the case of heavily contaminated engines, the proportion and working time on the flush can be increased. K2 Motor Flush has been on the market for over 20 years. Tested by thousands of workshops domestically and abroad. It is considered one of the most effective products in its category.

INSTRUCTIONS FOR USE:

1. The engine interior should be flushed immediately before changing the engine oil.
2. Before using the product, check the oil level in the engine; if it is not correct, top up the oil.
3. Then pour the entire contents of the package into the warmed-up engine.
4. Start the engine and leave it idling for 10 - 15 minutes.
5. Then turn off the engine and remove all used oil from the engine by gravity.
6. Replace the oil filter with a new one.
7. Pour the appropriate amount of new oil according to the car manufacturer's recommendations.

CAPACITY: 250 ml.